Anything of Best Wireless Doorbell is convenient because there is no complicated wiring unit and you do not have to worry about its installation process. The same goes with wireless doorbell, it is not just a hassle free experience, but also a very practical approach to doorbells, they come in good designs and the pricing is also very decent. However, one thing with any electrical appliance is that it may breakdown at some point; after all, it is a machine. When a doorbell gives up, it is only one fix away until it gears back into action.
It Can Be a DIY Project
In most cases, wireless doorbells have minor problems at some point or the other, which can be handled alone without having to depend on a technician. In fact, when you call in a professional, whether it is a small problem or a big one, you will spend a basic call out fee on them. You can avoid all this by opting for a DIY approach, below mentioned are some useful tips to help fix a wireless doorbell & Installing Wireless Doorbells
Items You Require
In order to fix a broken wireless doorbell, you would need only a handful of tools and items. All that you will need are:
- Needle pliers
- Wood shims
Opening the Cover
Start by opening the cover first, in most wireless doorbells, there is a back panel supported with screws. All you need to do is remove the screws and open the cover of the doorbells.
Check the Batteries’ Strength
Usually the problem lies when the battery power dies out. This is why you need to do replace the batteries first. If the new batteries do no good, then you should know that the problem lies elsewhere.
Check for the Frequency
There are two frequency indicators, one on the button and the other on the chime. Both should work on the exact same frequency, and it is located near the battery. If there exists a difference, you should move the jumper on either of the side so that they are set to being identical. You could make use of needle-nose pliers to help with the jumper settings. Once this is done, place the cover back and you are good to go.
What if it still does not work?
There could be a possibility that even with change of batteries or setting the frequencies, the wireless doorbell may not work. In such a situation, you still have another fix, all you need to do is remove the wireless doorbell from its spot and place it next to the doorbell button. If it works, it could be possibly because earlier it was installed next to metal studs that was interfering with the process.
Right Spot for Installation
It is extremely important that you install the doorbell at a higher spot up on the wall. Especially when you have a concrete wall, it shouldn’t be too close to the floor as the signals might be weakened there due to an interference. For good quality signal, installation at the right spot is vital. In fact, sometimes, changing the spot is all you need to get your wireless doorbell to work in the best manner possible.
There is nothing tedious or cumbersome about fixing a wireless doorbell. With basic problems come basic solutions and above mentioned are some useful tips to help you through the minor glitches and get the wireless doorbell back in action.